Steve's Music Center
248 Rock Hill Drive, P.O. Box 760
Rock Hill, NY 12775
Phone/Fax 845-796-3616

DigiTech JamMan Looper

DigiTech JamMan Looper
Includes CompactFlash Card and Power Supply

$299.95
Includes UPS Ground Shipping
in Continental U.S.
Buy Now

back
DigiTech

The optional FS3X Footswitch functions control next/ previous loop selection and Auto Record on/off.

$339.90 JamMan Looper
with FS3X Footswitch
Includes UPS Ground Shipping
in Continental U.S.
Buy Now - JamMan with FS3X Footswitch - $339.90

e-mail Steve

When DigiTech  invented the PDS8000 pedal almost twenty years ago, it stored eight seconds of audio. Using removable CompactFlash™ memory, the DigiTech JamMan® Looper pedal  can store up to 6.5 hours*! A wide range of features combined with ease of use make the DigiTech® JamMan® the perfect looper/phrase sampler for practicing, composing, and performing.

The JamMan opens up new horizons to your musical explorations. The possibilities are literally endless, endless, endless…!

  • Save up to 99 independent loops at one time.
  • Store over 24 minutes of looping time on the included CompactFlash card. Upgrade to a 2GB card to store up to 6.5 hours of audio!
  • Connect to your computer via USB and never lose another loop ever again!
  • Record rhythm loops and solo over them on the fly, completely Hands-Free™.
  • Load up the JamMan with bass lines, drums, harmonies, and more; create an entire backup band, take it with you, and perform anywhere!
  • Slow down or speed up any song without changing pitch to master that tricky riff.

*With optional 2GB card

Looper Modes

Instrument or Vocal Looping

Simple and easy:
  1. Select an empty memory location.
    Select INST/MIC as the recording mode using the RECORD MODE button.
  2. Press the REC/PLAY/OVERDUB footswitch to start recording.
  3. When you are finished, press either the REC/PLAY/OVERDUB footswitch to have the phrase play back in a repeating loop or press the STOP/TEMPO footswitch to stop recording.

Recording with the Aux Input

Want to play along with pre-recorded material or spice up your set with sounds from soundtracks or samples?
  1. Select an empty memory.
  2. Press the RECORD MODE button repeatedly to and choose the one that lights the AUX INPUT LED.
  3. Press the REC/PLAY/OVERDUB footswitch to start recording.
  4. When you are finished, press the STOP/TEMPO footswitch to stop recording.
  5. Press play to hear your recorded material.

Digital Delay Layers

Play into the layers:
  1. Connect the HardWire DL-8 Delay/Looper pedal before your amp or in your amps effects loop. 
  2. Set controls to:
    • - Level: 12 o’clock
    • - Repeats: 12 o’clock
    • - Time: 9 o’clock
    • - Mode: 1 Second
  3. Play into the delay for layered tones. For more layers, turn up the Repeats to 3 o’clock.

Solo Act Looper

Laying down loops is quick and easy:
  1. Connect the HardWire DL-8 Delay/Looper pedal before your amp or in your amps effects loop. 
  2. Set controls to:
    • - Level: 12 o’clock
    • - Repeats: Minimum
    • - Time: 9 o’clock (adjust as needed)
    • - Mode: Loop
  3. Hold down the foot pedal until the LED indicator turns red and play your loop. Release the foot pedal when done.
  4. LED indicator turns green, loop automatically plays.
  5. To add more layers, repeat step 3.

Specifications

Digital
A/D/A Converters: 24-bit audio
Sampling Frequency: 44.1 kHz
USB
Type: USB 1.1 Full Speed, supports USB 2.0
Protocol: Mass Storage
Connector: Type B

Memory
CompactFlashTM: Type I solid state only (Type II cards or IBM/Hitachi Microdrives™ not supported)
Size: 8 MB to 2 GB
Capacity: 1 minute per 5.29 MB, 99 loops per card
File Format: FAT16 only
Audio Format: Uncompressed .wav 44.1 kHz 16 bit mono

Inputs/Outputs
Instrument/Guitar Input: 1/4” Unbalanced (Tip-Sleeve)
Input Impedance: 1 MOhms
Maximum Input Level: 11 dBu
Microphone Input: XLR Balanced (Female XLR, pin 2 Hot), not powered
Input Impedance: 600 Ohms balanced
Maximum Input Level: -7.5 dBu
Auxiliary Input: 1/8” Stereo (Tip-Ring-Sleeve), sums to mono
Input Impedance: 20 kOhms
Maximum Input Level: 0 dBu
Footswitch: 1/4” jack (Tip-Ring-Sleeve)
compatible with optional FS3X
Line/Headphone Output: 1/4” Mono (Tip-Ring-Sleeve)
Stereo headphone compatible with 50 Ohms
minimum impedance, driven by mono signal
Output Impedance: 100 Ohms
Maximum Output Level: 10 dBu

Power
US and Canada: 1 20 VAC, 60 Hz Adapter: PS0913B - 120
Japan: 100 VAC, 50/60 Hz Adapter: PS0913B - 100
Europe: 230 VAC, 50 Hz Adapter: PS0913B - 230
UK: 240 VAC, 50 Hz Adapter: PS0913B - 240
Power Input: 9 VAC 1.3 A
Power Consumption: 7 Watts

General
Dimensions: 6.7” Width x 5.6” Length x 2.6” Height
Weight: 2.88 lbs

Specifications are subject to change without notice.

Product Resources

Questions? item or a price? Call or e-mail steve@stevesmusiccenter.com. Prices quoted are subject to change. Quantities may be limited on some items. Please contact us before ordering to verify availability. Click HERE for Return Policy.

$299.95
Includes UPS Ground Shipping
in Continental U.S.
Buy Now

back
DigiTech

HOME/SEARCH | acoustic guitars | amps | audio | basses | drums | effects a-f | effects g-z | electric guitars | guitar accessories
guitar tuners | harmonicas | mandolins / banjos | pickups | map/directions | meet Steve | e-mail Steve | Buy! review cart